WH type slider coupling

The WH type cross slide coupling is suitable for occasions where the transmission torque is small. It has the performance of compensating the relative offset of the two shafts and buffering. The working temperature is -20-+70℃.

WH type slider coupling has a nominal torque of 16-5000N.m, a permissible speed of 10000-1500r/min, a shaft hole diameter of 14-100mm, and a shaft hole length of 25-212mm. Slider coupling and cross slide The structure of the block coupling is similar. The different WH type cross slide coupling is noisy, low in efficiency, and fast in wear. Generally, it is not used as much as possible. It is only used when the speed is very low, such as a ball mill.Allowable compensation amount: axial △ x=1~2mm, radial △ y ≤ 0.2mm, angular △α≤ 40'. WH slider coupling is a type of coupling without elastic components. It is mainly used to allow the coupling of two shafts with radial offset. It consists of a half coupling with grooves on both ends and a square slider in the middle. The intermediate sliding block is used to slide in the corresponding radial grooves on the end faces of the coupling halves on both sides to realize the coupling of the two coupling halves.

WH type-slider coupling has high noise, low efficiency and fast wear. Generally, it is not used as much as possible. It is only used for occasions with very low speed, such as ball mills.In order to balance the situation, the bolts should be installed in reverse and reverse phases.

Because the middle cross slider is a square slider, the middle slider is used to slide in the corresponding radial grooves on the end faces of the half couplings on both sides to realize the coupling of the two half couplings.

江苏WH type slider coupling　Shandong WH type slider coupling