C Type Flex-Flex Couplings
The C Type coupling consists of two flex hubs, one sleeve and a single accessory kit consisting of seals and snap rings.
CFR Form Flex-Rigid Couplings
The CFR Style coupling consist of a single flex hub, a single rigid hub, one sleeve, one accessory kit consisting of seals and snap rings.
Features
Simple and low-cost form of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in spot
Accessible as vertical and horizontal couplings
Broad variety of particular variations which include full-flex, flex-rigid mill motor
Standard configurations are available from the shelf
Ordering Information and facts
Application: Driver and Driven.
Kind and dimension of coupling, horizontal, vertical and so forth.
Power: Motor horspower or torque requirement.
Pace: Motor RPM or Driven RPM.
Distance between shaft ends (BSE).
Shaft sizes.
C and CFR Variety Couplings
Ordering Information
Puller Holes are common on sizes four by means of twelve.
Puller Holes are available for sizes 7/8 through 3.5 at an extra charge.
The BSE (distance In between Shaft Ends) could differ among G and G1.
Interference bores without any set screws are conventional unless otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, seek advice from Engineering Segment.
Greater sizes are available, please talk to Technical Assistance.