Energy UNITS FOR LIFT TABLE 1
General Description
This electrical power unit is intended exclusively to the smaller lift table,Consisting of high pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This electrical power unit is extensively made use of within the business of logistic products including minifork lift, scissors lift and ariel doing work platforms. The lower-ing motion is managed by the solenoid valve with all the velocity managed by the adjustable needle valve.
Power UNITS FOR LIFT TABLE 2
Standard Description
This energy unit is developed exclusively for your medium lift table, Consisting of remarkably effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing movement is actived by the solenoid valve and also the velocity managed by the adjustable needle valve. When the lift rises to a substantial positoin, but the energy provide is reduce, the decreasing movement is controlled by the manual override perform.
Electrical power UNITS FOR LIFT TABLE three
Basic Description
This electrical power unit is intended exclusively for the big lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived from the solenoid valve as well as the velocity controlled by a stress compensated movement control valve.
Energy UNITS FOR LIFT TABLE 4
Standard Description
This power unit is intended solely for the huge lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived by the solenoid valve along with the velocity controlled through the adjustable needle valve. When the lift rises to a high positoin, but the energy supply is lower, the lowering movement is managed from the guide override perform.
Unique Notes
1. This energy unit is of S3 duty cycle, which might only work intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean each of the hydraulic components concerned prior to set up of the electrical power unit.
three. Viscosity from the oil shoud be 15~46 cst,which ought to also be clean and totally free of impurities.N46 hydraulic oil is recommended.
4. Oil transforming is required following the first 100 operation hours,afterwards as soon as every 3000 hours.
5. The energy unit shown is intended to be mounted vertically.