Materials Dealing with Energy UNIT two
This energy unit capabilities energy up gravity down circuit. Activate the begin solenoid to start out the motor to lift the machine. The lowing movement is activated by the solenoid valve with all the lowering pace controlled from the strain compensated flow handle valve. Items of this series is usually broadly used in the marketplace of logistic devices such as fork lift, mini lift table, and so forth.
one. The duty of this electrical power unit is S3,i.e.,30 seconds on and 270 senconds off.
two. Clean all the hydraulic components concerned just before mounting the power unit.
3. Viscosity with the hydraulic oil shoud be 15~46 cst,which should also be clean and totally free of impurities, N46 hydraulic oil is advised .
4. Oil transforming is needed just after the original 100 operation hours,afterwards after every single 3000 hours.
five. The energy unit need to be mounted horizontally.
Materials Handling Electrical power UNIT 1
This energy unit is developed for that fork lift field, consisting of extremely productive gear pump, DC motor, guide raise and lower valve, tank, ect. The up and down motion are controlled from the lever on the manual release valve, that is equipped with an electric switch to activate the motor. The lowing pace is managed from the strain compensated flow management valve.
one. The duty of this power unit is S3, i.e. thirty seconds on and 270 senconds off.
2. Clean all the hydraulic components concerned prior to installation of the energy unit.
three. Viscosity of the hydraulic oil shoud be 15~46 cst, which ought to also be clean and totally free of impurities, N46 hydraulic oil is advised .
four. Oil transforming is required right after the initial 100 operation hrs, afterwards after each and every 3000 hours.
5. The power unit shown is designed to be mounted horizontally.